BMW Tech Tip: Ignition Lock Spins Freely

BMW Tech Tip: Ignition Lock Spins Freely

The ignition lock cylinder on E31, E36, E38 and E39 models built prior to January 1999 was designed with an actuating tab that breaks off if forcing of the lock is attempted with the wrong key, or with some form of tool as part of a vehicle theft effort.

The ignition lock cylinder on E31, E36, E38 and E39 models built prior to January 1999 was designed with an actuating tab that breaks off if forcing of the lock is attempted with the wrong key, or with some form of tool as part of a vehicle theft effort.

The purpose of the breakaway tab is to prevent the lock assembly from being forced to the point where the cylinder breaks out of the housing, allowing the steering lock to release and the ignition switch to be turned with a screwdriver. Since the cylinder will spin freely, the required force cannot be applied to the assembly.

It’s possible to break off the tab if enough force is applied to the proper key, and the key has not been inserted completely into the cylinder. Even if the tab has been broken off, the lock will still operate, as long as the correct key is completely inserted into the lock.

Service Procedure:
If the tab has been broken off, the lock cylinder can be replaced, following repair manual instructions, Section 32 32 050. When the cylinder is removed, carefully inspect the inside of the housing to locate the tab and remove all broken-off pieces. It’s normally not necessary to replace the housing unless damage to the inside of the housing is evident.

Courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Mullen Road Tests Solid-State Polymer Battery Pack

The results met or exceeded all requirements targeted for the first drive cycles for energy usage and driving range.

Mullen Automotive began Class 1 EV cargo van road testing with an integrated solid-state polymer battery pack. Vehicle road testing began on Feb. 26 at Mullen’s Commercial Tech Center in Troy, MI.

Mullen’s latest phase of solid-state polymer battery testing began in January with the installation of the battery pack into the Class 1 EV cargo van for testing system compatibility between the vehicle and pack. Recent performance testing has included on-road drive cycles as well as Dyno testing at an EPA-certified lab located in Northville, MI, Mullen said.

TEXA Releases IDC5 CAR 76.5.0 Update

IDC5 CAR 76.5.0 is characterized by over 2600 new possible selections for the major makes on the market worldwide.

TurnOnGreen, Endliss Power Team up to Expand EV Charging

TurnOnGreen said it will leverage EPI’s expertise in administering and executing power purchase agreements with commercial clients.

Autel’s ADAS Bay Max Vehicle Lift

Learn how this lift integrates mechanical repair, four-wheel alignment, and ADAS calibration, prioritizing efficiency and space utilization in your shop.

Switch EV Trainer Provides Tailored EV Tech Training

The Switch EV Trainer includes all of the components of a modern EV drivetrain on a compact, insulated, mobile platform.

Other Posts

Tool Time Podcast: SATA USA

In this all new episode of the Tool Time Podcast, Nadine and Eric sit down with Chris Springer of SATA USA.

Elywhere Launches in North America

Elywhere chargers can be configured to support power in the 1 MW range, providing solutions for electric fleets.

#3 Screwdriver “Tips”

What appears as one of the most basic tools in your box is far from it.

#2 Calipers & Micrometers

Calipers and Micrometers are essential measuring tools when exact precision is required.