Cracking the Code, Understand Friction Material Edge Codes
Just about every brake pad or shoe you install has a cryptic code printed on the side of the friction material. As a technician, being able to read this code is just as important as the Dewy Decimal system is to a librarian. The “Edge Code” can tell you information about the product you are
Friction Material Selection
Because today’s lighter and more friction-efficient disc brakes have become very sensitive to differences in friction materials, the issue of selecting a quality brake pad is becoming increasingly relevant to the quality-conscious installer. To illustrate, aftermarket manufacturers of high-performance disc brakes offer literally dozens of racing pads that are qualitatively equal, but vary widely in
Always Inspect Hardware During Brake Repairs
Though it isn’t required, many brake experts recommend replacing the drum hardware when the brakes are relined to restore the brakes to like-new condition. But often the hardware isn’t replaced because it doesn’t seem necessary. Unless the hardware is badly corroded or shows obvious signs of stress, like severe heat discoloration or other visible damage,
Driveshaft Service
Driveshafts on most rear-wheel drive and four-wheel drive (4WD) vehicles are very durable. Most late-model driveshafts are not serviceable and do not have any lubrication points. But, this does not mean that they can’t wear, or even fail. Driveshaft problems can be spotted from the moment you put the vehicle in gear to pull it
Internal Engine Repairs: Why Head Gaskets Fail
A blown head gasket is bad news for any motorist. It means the cylinder head has to be removed, and possibly resurfaced, to replace the head gasket. If coolant has entered the cylinders and/or crankcase, additional repairs or a whole new engine may be needed depending on the extent of the damage. Anyway you look
Checking into Mode $06
Mode 06 is the actual system test data that OBD II looks at when it decides to set a pending code or a current fault code. If the test data is within the limits established by the vehicle manufacturer, the item gets a PASS and no codes are set. But if a value is out of range, OBD II flags it with a FAIL and keeps an eye on the component until the system monitor has run at least twice. Then, if the problem is still there, a DTC is set and the MIL light comes on.