Electronic Specialties Wire Piercing Test Clips

Electronic Specialties Introduces Wire Piercing Test Clips

These probes are designed to pierce wire insulation and tap readings in wires where a direct connection is not possible.

Wire Piercing Test Clips (619)

Electronic Specialties’ new Wire Piercing Test Clips (619) save time when the testing application requires tapping of live electrical readings.

The wire-piercing clip makes electrical contact with insulated wires, therefore no wire stripping is needed.

The clip pierces insulated wire sizes from 22 awg down to 14 awg.

Operation is simple, says the company, you just screw the contact needle in/out from the bottom. The sharp needle minimizes damage to the wire’s insulation.

These test clips are designed to work with most DMM/scope test lead kits.

They connect via standard size 4mm banana jack.

A test lead with straight banana jacks (not right angle types) are optimal, such as ES #142-1, will connect to this clip.

These probes are designed to pierce wire insulation and tap readings in wires where a direct connection is not possible. After use, special care should be taken to seal the point where the wire was pierced.

619 is sold as a set of two clips.

Literature and information can be obtained free by calling 800-227-1603.




Electronic Specialties, Inc.
Phone: 262-279-1400Fax: 262-279-1300

You May Also Like

Mueller Kueps Presents Redesigned Sensor Tap Series

Professionally restore NOX sensor hole threads.

Mueller-Kueps presents the redesigned Sensor Tap Series, to professionally restore NOX sensor hole threads. The combination of steel strength, double coating and 6 cutting edges makes it a breeze to cut through the heat-tempered steel and provide professional thread restoration for both light and heavy-duty diesel engines. 

A super short tap design with an integrated guide pin which is available in sizes M12 x 1.25, M14 x 1.5, M18 x 1.5, M20 x 1.5, and M22 x 1.5 makes it so users can find the perfect fit for any application.

Lisle Low Profile Fuel Line Disconnect

Designed for Ford vehicles with limited clearance between fuel line and high-pressure pump.

Dent Fix Soft-Shock Mallet DF-SM76 Reduces Damage

Apply firm precision taps for dashboards, head- or tail-light assemblies, windshield placement, plastic bumper covers, interior or exterior decorative trim, emblems, and GPR/PDR work.

New ProMAXX Diesel Fuel Injector Seal Puller/Saver ProKits

Ford Power Stroke 6.7L & GM Duramax 6.6L ProKits easily remove compression seals and shorten repair times

Mayhew Introduces New 14-Piece Micro Hand Tool Set

This new set is a compilation of all the current micro line products from Mayhew; including pry bars, picks, hooks and screwdrivers.

Other Posts

New Small Stud Extractor Now Available from Mayhew Tools

This new stud extractor, 1/4″ drive, allows for stud and bolt removal from tighter spaces with a wide option of driver abilities for job versatility.

Matco Debuts 5-Piece Purple Screwdriver Set

The purple screwdriver set includes a variety of sizes and types.

Mayhew Debuts New Fluorescent Handled Screwdrivers

The new screwdrivers, Slotted and Phillips, are part of the greater Made in the USA product line and are available as both sets and individual tools.

Snap-on Lights Up the New Year with New Lighting Tools

The three new lights are ready for technicians to use on the go.