Hunter Engineering Introduces ADASLink Diagnostic Scan Tool
Connect with us
Close Sidebar Panel Open Sidebar Panel


Hunter Engineering Introduces ADASLink Diagnostic Scan Tool

Complete step-by-step solution allows shops to keep ADAS alignment and calibration work in-house.


Hunter Engineering has introduced ADASLink, a premium, full-diagnostic scan tool that includes ADAS calibration and secure FCA gateway capabilities. This complete solution custom integrates with Hunter’s WinAlign software, providing the technician with quick access to specific calibration procedures for more than 25 million vehicles.

Click Here to Read More

Advanced driver-assistance systems (ADAS) is the fastest-growing automotive technology today, yet comparatively few service providers are prepared to perform the intricate ADAS calibrations increasingly required by manufacturers. The new ADASLink scan tool expertly closes that gap with comprehensive ease and precision.

ADASLink guides the technician with clear, step-by-step on-screen instruction, ensuring the calibration is completed according to OE requirements. Access to accurate ADAS data is critical, since these complex safety systems require recalibration following a wide range of typical services, such as wheel alignment, suspension repair or windshield replacement.

The versatile tool also provides thorough pre- and post-repair scan insurance documentation through HunterNet 2, Hunter’s online customer software portal.

Dynamic calibrations are supported by ADASLink alone. For static, in-bay calibrations, ADASLink combines with the Bosch DAS3000, using built-in cameras and rear wheel-mounted targets to position the fixture in front of the vehicle, thus removing the need for string, plumb bobs and tape measures.


For the 2020 model year, 93% of vehicles came equipped with at least one ADAS component. ADASLink enables shops to take control of this challenging work by decreasing steps, increasing efficiency and cutting calibration time in half.

“For shops inexperienced in ADAS work, calibrations can be very confusing, if not intimidating,” said Ryan Gerber, product specialist with Hunter. “ADASLink removes all the guesswork by carefully walking the tech through the entire process, allowing shops to perform this profitable and important service in-house instead of subletting it to others.

For more info:

Click to comment
Tech Shop Magazine