This unique tool was designed to remove and
install lower ball joints on the car versus removing the steering knuckle and
using a press. Using an air hammer, the job of removing and installing
ball joints is a simple procedure saving one hour per side.
The tool has two main parts that attach to the air hammer, a remover and
installer. The remover easily fits over the lower end of the ball joint
to drive the old ball joint out of the steering knuckle. The installer
has been designed to fit around the upper portion of the steering knuckle
enabling a straight push for the new ball joint. The installer couples
with one of three different sizes of installer heads that drive in the new ball
joint without damaging it.
Works with “Spring Type” tool
retainer air hammers.
Prelude 1988-1991 & 1996-1998
additional information, visit http://www.sptool.com/.