Emissions Archives - Page 15 of 15 - TechShop Magazine
Replacing Oxygen Sensor: Saving the Environment and Your Customer’s Catalytic Converter

The oxygen (O2) sensor is the master switch in the fuel control feedback loop. The sensor monitors the amount of unburned oxygen in the exhaust and produces a voltage signal that varies from about 0.1 volts (lean) to 0.9 volts (rich). The computer uses the O2 sensor’s signal to constantly fine tune and flip-flop the

OBD II Diagnostics: Checking into Mode $06

In this scan tool diagnostics article, we take a look at Mode $06 functions which govern non-continuous monitors (EVAP, catalyst, EGR, etc.)

Monitoring Emission Efficiency With O2 Sensors

As modern OBD II technology marches on, it’s clear that the zirconia-based oxygen sensor now is being sold more as a basic repair part than as a preventive maintenance part, and it changes the way we diagnose and sell oxygen sensors. To illustrate the difference, let’s remember that an oxygen sensor replacement used to be

Checking into Mode $06

Mode 06 is the actual system test data that OBD II looks at when it decides to set a pending code or a current fault code. If the test data is within the limits established by the vehicle manufacturer, the item gets a PASS and no codes are set. But if a value is out of range, OBD II flags it with a FAIL and keeps an eye on the component until the system monitor has run at least twice. Then, if the problem is still there, a DTC is set and the MIL light comes on.