Tech Tip: Dodge Has A P2767 Code With Transmission In Limp In Mode

Tech Tip: Dodge Has A P2767 Code With Transmission In Limp In Mode

If you encounter a Dodge with a P2767 trouble code set, check the wiring between the transmission and the transmission control module. Make sure the #2 signal wire is not open, shorted to ground, or shorted to any other circuit. If the wiring checks OK, raise all four wheels off the ground, start the vehicle and place the shifter in drive. While lab scope testing the #2 signal wire, obtain second gear. When the transmission is in second gear, there should be a 5-volt square wave pattern being produced by the #2 sensor. If not, replace the sensor.

Applies To:
2006 300 3.5L
2006-’07 300 5.7L
2006-’07 Charger 3.5L
2006-’08 Charger 5.7L
2009 Grand Cherokee 3.7L
2006 Magnum 5.7L

Customer Concern:
P2767 trouble code (Torque Conv Clutch Press Ctrl Solenoid Ctrl Circ Range/Perf) is setting. Transmission is in limp in mode.

Potential Causes:
Lead Frame or Transmission Wiring

Tests/Procedures:
1. Check the wiring between the transmission and the transmission control module. Make sure the #2 signal wire is not open, shorted to ground, or shorted to any other circuit.

2. If the wiring checks OK, raise all four wheels off the ground, start the vehicle and place the shifter in drive. While lab scope testing the #2 signal wire, obtain second gear. When the transmission is in second gear, there should be a 5-volt square wave pattern being produced by the #2 sensor. If not, replace the sensor.

Tech Tips:
The speed sensors are sold as a complete assembly, which may be called the “lead frame” or ­possibly the “electrohydraulic control unit.”

Courtesy of Identifix.

You May Also Like

Snap-on Continues to Offer Free Weekly Product Training Sessions

The online training and question and answer sessions are free of charge.

Snap-on national training manager Keith Wray will continue to hold weekly new product training sessions throughout the year that give professional technicians the opportunity to learn more about Snap-on Fast-Track Intelligent Diagnostics tools such as the ZEUS, TRITON and APOLLO series. 

The online training and question and answer sessions are free of charge and are conducted as follows:

BendPak to Debut Eight-Armed Car Lift Concept at NADA

Octa-Flex improves technician productivity, convenience and ergonomics, according to BendPak.

Matco’s New Ghost Cart: Where Tools and Style Spookily Align

Haunt your shop with efficiency: Matco’s 2023 Ghost Cart is sleek and functional.

Matco Ghost Cart tool storage
New Cool Boss CB-26: Plug In and Chill Out 

Portable evaporative cooler drops temperature up to 26 degrees at work or play.

Updated Jump-N-Carry 12V Jump Starter, Power Supply

Delivering 550 Start Assist Amps of starting power, the JNC345 can tackle a wide variety of starting tasks.

Other Posts

TechShop, ShopOwner Offer $50 For Good Guesses

Guess the Tool for a chance at cold hard cash!

TS Toolbox Guide February 2024

Here’s a look at some of the core feature and modern frills to consider when it’s time to move into a new office.

toolbox guide illustartion
Embracing Cutting-Edge Solutions the Industry has to Offer

Embracing cutting-edge solutions is strategic and imperative for technicians navigating the constantly changing landscape of automotive maintenance and repair.

Nadine Battah
Repairify Announces Executive Leadership Changes

The company has named Craig Edmonds as president of asTech among other executive appointments.