Mohawk Lifts on Quality

VIDEO: Mohawk Lifts on Quality and Efficiencies

Hear how to increase shop productivity, efficiencies and profits in this new video interview with Mohawk Lifts.

While at the 2017 SEMA Show, TechShop’s Senior Editor Brendan Baker had the chance to speak with Steve Perlstein from Mohawk Lifts.

Steve discusses the differences between Mohawk’s 100% made-in-the-USA lifts and other products in the market. You’ll also hear how a Mohawk Lift can increase shop productivity by eliminating several minutes of positioning a car on the swing arms.

For more information, visit mohawklifts.com.

Mohawk Resources, Ltd.
Phone: 800-833-2006Phone: 518-842-1431Fax: 518-842-1289Contact: Steve Perlstein

You May Also Like

Mazda Front Radar Calibration

Watch to learn how to calibrate the front radar on a Mazda.

Joe Keene, automotive content video producer at Babcox Media, performs a Mazda millimeter-wave radar calibration with the aid of an alignment laser, radar reflector stand and Hunter’s ADASLink diagnostic scan tool. This video is sponsored by Hunter Engineering Co.

BMW Front Radar Sensor Calibration

Joe Keene discusses how to calibrate a radar sensor on a 2017 BMW 750i xDrive.

Audi Driver Assistance System Front-facing Camera Calibration

Joe Keene discusses how to calibrate the front camera on an Audi Q3 after the windshield was replaced.

VIDEO: Mazda Front Camera Calibration

Joe Keene discusses how to calibrate the front camera on a Mazda 6 after the windshield was replaced.

VIDEO: Mazda Blind Spot Monitor Calibration

Joe Keene discusses how to calibrate the blind spot monitoring system on a 2020 Mazda 6 Grand Touring.

Other Posts

TPMS: Are Retrofits in Your Future?

Installing a retrofit kit can be performed with the tools and equipment you already own and use on a daily basis.

Tire tread
Maximize Your Scan Tool

Are you maximizing your scan tools to their full potential? Don’t let them be just an expensive code reader.

Scan Tool
Upgrade Your Air System: It’s Easier Than You Think

Improving your shop airflow is only a benefit, unless you like to spend more time, work harder and make less money.

air flow tubes
Milwaukee’s Next Gen M18 FUEL 1/2″ High Torque Impact Wrenches

The M18 FUEL ½” High Torque Impact Wrenches are fully compatible with the entire M18 line.