Hunter’s Weight Placement Laser Improves Speed and Accuracy of Balancing Service
Hunter’s new HammerHead TDC placement laser system virtually eliminates operator clip-weight placement errors by projecting a laser line guide onto the tire sidewall and rim edge. The HammerHead lasers show the technician the exact top-dead-center position independently at each rim edge, ensuring precise weight placement, reduced check-spins and the fastest possible "floor-to-floor" service.
Hunter’s New WinSI Inspection Lane Software Adds Service, Sales and Management Capabilities
The next generation of WinSI software for Hunter’s PC-based automated brake, sideslip and suspension systems introduces five new or upgraded capabilities that expand the systems’ service, shop management and merchandising capabilities. An upgrade version of the software is available for shops with Hunter PC-based Inspection Lane equipment already installed.
Hunter’s PowerSlide Slip Plates Save Alignment Technicians Time and Effort
Hunter’s PowerSlide slip plate locking mechanism secures the rear wheel slip plates with the touch of a button. With PowerSlide slip plates, technicians no longer have to make extra trips around the vehicle or struggle to remove and replace lock pins during alignment procedures.
Hunter’s New PowerSlide Slip Plates Save Technicians Time and Effort when Performing Alignments
Hunter’s new PowerSlide slip plate locking mechanism secures the rear wheel slip plates with the touch of a button. With PowerSlide slip plates, technicians no longer have to make extra trips around the vehicle or struggle to remove and replace lock pins during alignment procedures.
Hunter Introduces PowerSlide Alignment Lift Turnplate and Slippage Locking System
Hunter Engineering Co.’s PowerSlide alignment lift turnplate and slippage locking system secures plates with the touch of a button. Technicians no longer have to make multiple trips around the vehicle or struggle to remove and replace lock pins during alignment procedures.
Hunter Offers Wide Variety of Training Classes
Hunter Engineering Company annually trains thousands of students and experienced service technicians at the Research and Training Center in St. Louis, MO, at other regional training centers located throughout the country and through local Hunter representatives.
Hunter’s New OCL400 Anti-Chatter Technology Eliminates Fixed Speed Machining Vibration Problems
Hunter’s new ACT (Anti-Chatter Technology) equipped OCL400 On-Car Brake Lathe virtually eliminates the buildup of vibration (chatter) that can occur when machining rotors at a fixed speed. The ACT feature oscillates the machining speed of the lathe during the cut. The result is a smoother finish that prevents pedal pulsation – the number one cause of brake service customer “comebacks.”
Introduction to the Maverick Tire Changer
Joe Keene speaks with Hunter Engineering service rep Rick Marzen on Hunter’s premium center-clamp Maverick tire changer.
Toyota RAV4 Pre-Collision System ADAS Calibration
Watch as Joe Keene does a front milliwave radar system calibration on a RAV4. This video is sponsored by Hunter Engineering.
2020 GMC Yukon Denali Front Radar Calibration
Learn how to perform a front radar calibration on a 2020 GMC Yukon Denali. This video is sponsored by Hunter Engineering Co.
