Tech Tip: Customer Complaining of Failing a Smog Test?

Tech Tip: Customer Complaining of Failing a Smog Test?

Do you have a customer who has a car that just can’t seem to pass a vehicle “smog test” to obtain a vehicle registration sticker? Depending on the state or county, vehicles need a smog check test every other year in order to re-register the car or truck with that state's Department of Motor Vehicles.

Do you have a customer who has a car that just can’t seem to pass a vehicle “smog test” to obtain a vehicle registration sticker? Depending on the state or county, vehicles need a smog check test every other year in order to re-register the car or truck with that state’s Department of Motor Vehicles.

The Automobile Club of Southern California recommends the following maintenance tips to ensure your customers’ vehicles are operating cleanly to pass a state-mandated smog check. However, the tips are intended to ensure that vehicles that should pass a smog check test do, and are not intended to “fool” the test equipment, according to an Auto Club spokesperson.

Most tips are especially important for teens, college students, retirees, telecommuters and others who are “short trip” drivers. If after following these tips the vehicle fails, then the vehicle needs a professional assessment of its emissions-related systems.

You can help your customers by offering the following 10 simple tips and advice:
1. Make sure the tires are in good condition and properly inflated.
2. Make sure the check engine light or any other dashboard warning lights are not on.
3. Make sure that the vehicle has no fluid leaks and no safety issues. Remember, the vehicle will be strapped down on a dynamometer and required to perform flawlessly under stressful conditions.
4. Don’t change the size of the tires from the original specifications. The dynamometer test equipment is calibrated to the “stock” tire size. Over- or under-sized tires will alter the speed calculations performed by the test equipment and may prevent the vehicle from going through the test since the machine won’t sense the correct speed for the vehicle’s tire size.
5. Make sure the vehicle has a clean air filter and fresh engine oil.
6. Make sure the vehicle’s gasoline cap fits the vehicle, isn’t damaged and is turned tightly in place. A vehicle without a gas cap is an automatic smog check test failure.
7. The week of the smog check test, take the vehicle out for an extended drive, preferably on the freeway and especially if they’re regularly a “short trip” driver. Drive approximately 30 minutes or longer at varying speeds on freeways, surface streets and up hills.
8. On the day of the test, have your customer fill the gas tank of your vehicle with the grade of fuel stated in the owner’s manual.
9. Make sure all fluids are topped off and that all non-essential items are removed from the trunk or the rear of the vehicle. The dynamometer weighs your vehicle before the test, and if the vehicle is heavier than it should be, the weight will make it harder to pass.
10. Drive at least 30 minutes before arriving at the smog check test facility to ensure the car or truck has reached full operating temperature.

Source: Automobile Club of Southern California.

You May Also Like

Clarios Formalizes Joint Development Agreement with Altris

Altris will develop sodium ion cells for low-voltage tech while Clarios will lead in battery management systems, software, and system integration for battery design.

Clarios and Altris, a Swedish developer and prototype manufacturer of sodium-ion batteries, announced an exclusive Joint Development Agreement (JDA) for low-voltage mobility applications.

Under the new JDA, Altris will focus on developing the sodium ion cell technology for low-voltage applications, while Clarios will leverage its expertise in Battery Management Systems (BMS), software, and system integration to design the battery system. This development agreement enhances a collaboration agreement initiated earlier this year, which set in motion the creation of a detailed production plan for low-voltage vehicle batteries utilizing sodium-ion cells, the companies said.

Less is More with Cordless Work Lights

The automotive industry has reaped the benefits of LED lights more than any other industry.

Streamlight Wedge XT
Eaton to Supply ELocker Differential System to EV Manufacturer

The system leverages an electric motor to power the rear wheels and an electric motor or an optional ICE driving the front wheels.

Servicing EVs in Your Shop

Technicians need to learn how to correctly diagnose and repair electrical systems.

technician using laptop
Tool Time Podcast: Schrader TPMS

In this episode, Nadine and Eric sit down with Yanick Leduc to discuss all the TPMS solutions his company has to offer.

Other Posts

Eli Opens Reservations for its Micro-EV in the US

The new Eli ZERO represents a new category of high-tech, efficient and sustainable micro-EVs, according to Eli Electric Vehicles.

Hunter Engineering Releases New Alignment Coverage

Semi-annual specification update includes new and existing records.

#11 LED Work Lights

Light emitting diodes (LEDs) were a revolutionary development of electrical science.

LED Work Lights Feature
Eaton Receives 2024 Automotive News PACEpilot Award

Eaton was recognized for its 4-speed electrified vehicle transmission.