Tech Tip: Honda Pilot's Compressor Clutch Has Taken Off

Tech Tip: Honda Pilot’s Compressor Clutch Has Taken Off

Owners of Honda Pilots my experience no A/C compressor clutch. The scan tool says A/C off and A/C switch off. There is no air out of the front vents, but the blower motor operates and changes speeds with the front switch. To diagnose this probrlem, ground the blue/red wire at the front blower power transistor and verify the blower motor runs on high speed.Then verify the front blower power transistor ground is good on the black wire - look for 0.05 volts or less to be OK ....

Vehicle Description: 2004 Honda Pilot 3.5L

Mileage: 76,975

Customer Concern: No A/C compressor clutch. The scan tool says A/C off and A/C switch off. There is no air out of the front vents, but the blower motor operates and changes speeds with the front switch.

Tests/Procedures:
1. Ground the blue/red wire at the front blower power transistor and verify the blower motor runs on high speed.

2. Verify the front blower power transistor ground is good on the black wire — look for 0.05 volts or less to be OK.

3. Check the control signal from the climate control unit to the front blower power transistor on the orange/black wire. Look for voltage to be present when the front blower motor switch is turned on.

4. Unplug the front blower power transistor connector and remove or cut the orange/black wire from the front blower power transistor connector, then plug the front blower power transistor back in and use a powered up test light on the terminal of the front blower power transistor that the orange/black wire would normally go to and see if the front blower motor will operate then.

5. Check the blower feedback (ground side of the blower motor back through the front blower power transistor) back to the climate control unit on the second blue/black wire in the connector.

Potential Causes: Front blower power transistor; this was the confirmed fix. It turned out to be the rear blower motor that was running and not the front blower motor.

Tech Tips: It is not uncommon for a technician to believe the front blower motor is working when it is actually the rear blower motor that is working. This vehicle has two blower motors. The front blower motor is under the right side of the dash near the right kick panel. The rear blower motor is located near the floor in the center console below the radio and heater controls. The A/C compressor will not work if the front blower motor is not operating. The front blower power transistor (located near the front blower motor) controls the ground for the front blower motor. The front blower power transistor is controlled by the climate control unit. The front blower power transistor has blower feedback to the climate control unit for the climate control unit to know if the front blower motor is being grounded to turn it on.

From the Identifix Hotline Archive.

Courtesy of Identifix.

For more information, visit www.identifix.com.

You May Also Like

New Snap-on Limited Edition Speed Demon Roll Cab

Features include next-level organization, durability, security, mobility and exclusive Speed Demon emblem.

The new Snap-on KETP682A3WHZ Limited-Edition Speed Demon EPIQ 68" Roll Cab adds “wow” factor in a tool storage showpiece. Next-level organization, durability, security, mobility, and the exclusive Speed Demon emblem represents everything enviable about working in the industry that keeps the world moving.

“The Speed Demon’s exclusive badging features an intricately detailed skull intertwined with pistons and an engine, symbolizing speed and the rebellious spirit that comes with being part of the automotive and heavy-duty worlds that combine high-level skills with high-level power,” says Angelo Gargano, Snap-on Product Manager. “The fusion of skull and pistons evokes a sense of raw energy and daring, while the meticulous craftsmanship of this roll cab reflects both techs’ and Snap-on’s dedication to quality and innovation.”

AMD-035 Membrane Dryer Provides Ultra-Clean & Ultra Dry Air

The dryer has a flow rating of 35 SCFM and maximum working pressures of 150 PSI.

BendPak Full-Rise Scissor Lift Delivers Two-Post Performance

SP-7XE scissor lift lays flat and raises a vehicle six feet with an open center below.

BendPak to Debut Eight-Armed Car Lift Concept at NADA

Octa-Flex improves technician productivity, convenience and ergonomics, according to BendPak.

Matco’s New Ghost Cart: Where Tools and Style Spookily Align

Haunt your shop with efficiency: Matco’s 2023 Ghost Cart is sleek and functional.

Matco Ghost Cart tool storage

Other Posts

Cordless vs. Pneumatic: The Battle Continues

What does the future hold? Will one gain the upper hand over time?

Red and Blue toy robots boxing
TS Toolbox Guide February 2024

Here’s a look at some of the core feature and modern frills to consider when it’s time to move into a new office.

toolbox guide illustartion
Embracing Cutting-Edge Solutions the Industry has to Offer

Embracing cutting-edge solutions is strategic and imperative for technicians navigating the constantly changing landscape of automotive maintenance and repair.

Nadine Battah
TPMS: Are Retrofits in Your Future?

Installing a retrofit kit can be performed with the tools and equipment you already own and use on a daily basis.

Tire tread